Function:

 POWER HOUSE FCBC are designed to
 supply continuous power to the DC load
 and simultaneously charge the batteries
 connected. Input supply form 415 V. AC 3
 Phase or 220 V. AC 1 Ph.  is converted to
 regulated DC. The charger has two
 independent systems.

 Normally the DC power is supplied to he
 load by the Float Charger. It also supplies
 trickle current to the battery to keep it
 healthy. If the charging current under
 Float Mode exceeds a set level, Boost
 charger is switched ON. It supplies Quick
 charging current to the battery. On
 battery reaching the set value, the Boost
 Charger is switched OFF.

 Application:


 Float/ Boost chargers are must in Power
 Substations, Generating station, Telephone
 Exchanges etc. for control / monitoring
 systems, tripping circuits and supplying DC
 power stations, source.


 Ordering information:

 • Mains supply voltage    
 • Load voltage and current
 • Battery type, Voltage and current

Specifications:
 

Aux	: 415V. AC ( 3 Phase) / 240 V (1Phase)    +/- 20 %/ +/- 10%,  50 Hz. +/- 3 Hz.
Output	: 30 V, 48 V, 110 V and 220 V DC supply
Battery Type	: Lead Acid / SMF
Indications and instruments	: Indications for 3 phase mains supply
	: Float / Boost section
	: AC Volt meter with selector switch
	: DC Volt meter with selector switch and    battery volt
	: DC Amps meter for load
	: DC Amps meter for Charging.
Protection	: MCB for Mains incoming supply
	: MCB for out put load
	: Over load cut out by electronics circuit
	: Over Voltage cut-out by electronics    circuit
	: Single phasing, under voltage for mains
Housing and enclosure	: Heavy duty Sheet Steel enclosure    finished with powder coated paint.
Mounting	: Floor mounting
Operation	: Auto/Manual
Control	: CC/ CV close loop
Rectifier	: Full wave half controlled bridge
Optional	: Fuse protection for each rectifier   element.
	: Fuse failure relay
	: DC Earth Fault Relay
	: Alarm Annunciation
	: Dual Float Charger option
	: Any other as per requirement.